 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2330-385-14
4-36. SLACK ADJUSTER REPLACEMENT (CONT).
(5)
Position boot (6) or slack adjuster (7).
(6)
Install tie down strap (8) on boot (6) and
slack adjuster (7).
Use care when installing
retaining rings. Retaining rings
are under tension and can act as
projectiles when released and
could cause severe eye injury.
NOTE
Attempt to align the holes in
clevis and slack adjuster as
closely as possible when
installing slack adjuster.
(7)
Lubricate splines of camshaft (9) with
grease.
(8)
Install washer (10), slack adjuster (7),
washer (11) and retaining ring (12), on
camshaft (9).
(9)
Install pin (13), pin (14) and two cotter
pins (15) and (16) on clevis (1) and slack
adjuster (7).
(10) Turn jam nut (17) on push rod (2) against
locking collar nut (5). Tighten jam nut to 20
to 30 lb-ft (27-41 N.m).
(11) Refer to (Para 4-8) and apply grease to
fitting (18) until grease purges from pressure
relief seal under pawl button (19).
4-428
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals