|
| |
TM 9-2320-364-34-3
18-168
18-13. CONTAINER HANDLING UNIT (CHU) KIT INSTALLATION (CONT).
Use care when removing snap and
retaining rings. Snap and
retaining rings are under spring
tension and can act as projectiles
when released and could cause
severe eye injury.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
NOTE
Short struts can be found in
box E, pack no. 34 of CHU
kit crate.
Retaining ring, ring support
and pin can be found in box
B, pack no. 42 and 43 of
CHU kit crate.
Hole in short strut for
attaching spring should be
located on top.
Beveled edge of spacer faces
bearing in short strut.
(134)
Apply light coat of grease to outer surface
of pin (167) and install pin, short strut
(168), ring support (169) and retaining ring
(170) on pin bracket assembly (166).
NOTE
Wire rope and hardware can be
found in box B, pack no. 14 of
CHU kit crate.
(135)
Apply sealing compound (loctite 242) to
threads of screw (171).
(136)
Position screw (171), washer (172) and
loop end of wire rope (173) on right rear
roller bracket (125). Do not tighten screw.
166
170
169
168
167
171
172
125
173
|
