 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TB 9-2320-279-13&P-2
ROOF ARMOR REPLACEMENT - CONTINUED
0024 00
REMOVAL - CONTINUED
4
6
5 (HIDDEN)
7,8,9
2,3
1
(HIDDEN)
24,25,26,27
23
10,11
22
(HIDDEN)
13,14
417-044
15,16
12 (HIDDEN)
20,21
17,18,19
CLEANING AND INSPECTION
INSTALLATION
1.
Install two storage brackets (23), four washers (27), bolts (26), washers (25), and new locknuts (24) on roof armor (6).
2.
If removed, install escape hatch seal (12) around escape hatch opening of roof armor (6).
3.
Install stud plate (14) and lifting eyes (13) on roof armor (6).
4.
Install stud plate (1) on left-front edge of roof armor (6). Attach stud plate to roof armor with two new loosely installed
locknuts (2).
5.
Install stud plate (22) on left-rear edge of roof armor (6). Attach stud plate to roof armor with two new loosely installed
locknuts (15).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Roof armor weighs 166 lb (75 kg).
6.
Attach sling and lifting device to two lifting eyes (13).
7.
Use lifting device, install roof armor (6) on cab roof, aligning holes in right side of roof armor with holes in cab roof.
8.
Remove sling and lifting device from roof armor (6).
0024 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals