CREW PROTECTION ARMOR KIT ASSEMBLY PROCEDURES

II106700-5

Rev. B

CREW PROTECTION ARMOR KIT ASSEMBLY PROCEDURES

WARNING

THE EDGES OF THE METAL ARMOR PANELS MAY BE SHARP.

PROTECTIVE GLOVES SHOULD BE WORN BY THE INSTALLATION TEAM

TO PREVENT PERSONAL INJURY.

THE HEMTT ARMOR COMPONENTS ARE HEAVY ITEMS THAT REQUIRE

MORE THAN ONE PERSON AND / OR APPROPRIATE MATERIAL

HANDLING EQUIPMENT (HOIST, FORKLIFT, ETC.) FOR HANDLING. THE

WEIGHTS OF THE COMPONENTS BEING INSTALLED ARE SUFFICIENT TO

CAUSE SERIOUS INJURY OR LOSS OF LIFE. CARE MUST BE TAKEN

DURING INSTALLATION TO PREVENT INJURY.

HOISTING OPERATIONS HAVE INHERENT HAZARDS THAT CANNOT BE

MECHANICALLY SAFE-GUARDED. PERSONNEL ARE REQUIRED TO

WEAR HARD HATS AND SAFETY SHOES DURING INSTALLATION TO

PREVENT PERSONAL INJURY.

CAUTIION

CAUT ON

During the application of paint or the re-application of paint, care must be taken

to prevent covering up installation aid markings [THIS SIDE OUT, up arrows (↑),

etc.]. These installation aid markings must be protected during paint application

by using masking tape, paper, etc.

NOTE

Adjust the installed kit components, as necessary, prior to securing / tightening

the attachment hardware.

5.1 INSTALL ARMOR PANELS

Install Armor Kit, Windshield, HEMTT, P/N 106701-4

CAUTIION

CAUT ON

The pressed studs used in various windshield mount components are subject to

damage if proper precautions are not used. DO NOT hammer on the studs, as

this may cause them to separate from the brackets. DO NOT use power impact

wrenches to install locknuts on these parts; use light oil on the threads and hand

tools to run the nuts down. DO NOT exceed Grade 5 torque values for these

studs

Adjust the installed kit components, as necessary, prior to securing / tightening

the attachment hardware.

0039 00-40