|
|
II106700-5
Rev. B
Page 63
Figure 36A. Remove the drag link from the pitman arm on the steering box.
B. Disconnect the drag link (3) from the pitman arm (8).
2. Use the drill template (P/N 107406-1) to locate the through-hole locations on the
driver's-side fender support behind the cab (see Figure 37).
3. Mark and center-punch the hole locations and drill four pilot holes through the
bottom surface of the driver's-side fender support using a right-angle drill and a
1/4-in. drill bit (See Figure 37A).
0039 00-73
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |