Re-Install the LH and RH Door-Mounted Outside Mirrors

II106700-5

Rev. B

5.1.11 Re-Install the LH and RH Door-Mounted Outside Mirrors

a. Position the LH outside mirror frame and mirror on the outside of the LH door.

b. Apply Loctite 242 to four bolts (1/4 20 x 1.750 LG).

c. Attach the mirror frame to the door using the four prepared bolts

(1/4 20 x 1.750 LG), four flat washers (1/4 ID), and four locknuts (1/4 20).

d. Torque the locknuts to 9 ft-lb.

e. Repeat Steps "a" through "d" for the RH Door-Mounted Outside Mirror.

5.1.12 Re-Install the Cab Steps (with the Internal Clearance Light)

a. Apply Loctite 242 to four bolts (5/16 18 x 1.250 LG).

b. Position the hard metal cab step onto the bottom surface of the driver's-side Blast

Deflector using the four previously prepared bolts (5/16 18 x 1.500 LG),

eight washers (5/16 ID), and four locknuts (5/16 18). Torque the locknuts to

18 ft-lb.

c. Plug the wiring harness into the Clearance Light. Use the extra Pigtail Harness (P/N

111438-3) supplied in the Side Armor Panel Kit, P/N 103703-9, -10.

Repeat Steps "a" through "c" for the passenger-side cab step.

5.1.13 Re-install the Blackout Light

a. Remove the Blackout Light from the old bracket and install it in the new bracket,

(P/N 111459-1), using the same hardware (see Figure 48B).

b. Extend the vehicle Blackout Light wiring connection using the Pigtail Harness,

(P/N 111438-3) supplied in the Front Armor Protection Kit, P/N 106705-3.

c. Re-connect the vehicle Blackout Light wire connection using the Pigtail Harness,

(P/N 111438-3)

5.1.14 Re-Install the Bridge Weight Sign

a. Re-install the Bridge Weight Sign over the holes provided on the passenger side of

the Upper Brush Guard Cover (P/N 111437-1) and secure it in place using two bolts

(1/4 20 x 1.250 LG), four flat washers (1/4 ID), and two locknuts (1/4 20) (See

d. Torque the two locknuts to 9 ft-lb.

0039 00-89