|
|
II113300-1-103
Rev. A
The equipment and materials required to install the CPK onto the PLS are provided in Table 16.
Description
Part Number
Automotive General Mechanics Tool Kit
SC5180-90-N26
2.5-Ton Floor Jack
Commercially Available
8-in. C-Clamps
Commercially Available
Fork Lift / Overhead Hoist
Commercially Available
1/2-in. Drill
Commercially Available
1/4-in. Drill Bit, 3-16-in. Drill Bit
Commercially Available
3/8-in. Drill Bit, 7/16-in. Drill Bit
Commercially Available
17/32-in. Drill Bit
Commercially Available
7/8-in. Drill Bit
Commercially Available
Loctite 242 (Blue)
Commercially Available
Wire Ties
Commercially Available
Caulking Gun
Commercially Available
Lift Straps
Commercially Available
3/8-in.-Drive 0-90 ft-lb Torque Wrench
Commercially Available
1/2-in.-Drive 0-150 ft-lb Torque Wrench
Commercially Available
3/4-in.-Drive 0-280 ft-lb Torque Wrench
Commercially Available
5/16-in. 18 Rivnut Installation Tool
AKPT518TAK or equivalent
Commercially Available
3/8-in. 16 Rivnut Installation Tool
AKPT616TAK or equivalent
Commercially Available
1/4 3/4 Uni-Bit
Commercially Available
#50 Torx Socket
Commercially Available
These Installation Instructions will provide the illustration directly after that installation callout,
and the text will be on either the same page or the facing page, where practical.
Before beginning the assembly of a part, remove all corrosion-preventative compound (if any)
and any accumulated foreign matter.
Selected screws and bolts will require to be installed with Loctite 242. These screws and bolts
are identified in the installation instructions.
Unless otherwise specified in the instructions, use the torque values provided in Appendix A to
torque all fasteners.
0037 00-27
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |