Figure 4. Cab Step.

II113300-1-103

Rev. A

c) Remove the right and left Cab Steps mounted under the cab. This is done by removing

two bolts and disconnecting the link that is attached to the bottom of the cab (see

Disconnect chain link

Remove these bolts

Cab Step

Figure 4. Cab Step.

d) Remove the Windshield Wipers from the front of the vehicle. This is done by removing a

nut that is located at the pivot point of the Wiper.

e) Remove the Brush Guard mounted to the front of the vehicle (see Figure 5). The Brush

Guard is mounted all around its perimeter with bolts and nuts. The Brush Guard weighs

approximately 100 lb, and must be supported before removing all of the fasteners.

Remove the Glass Windshields and the rubber retaining channel (see Figure 5).

WARNING

THE WINDSHIELD GLASS CAN BREAK UNEXPECTEDLY DURING

THE REMOVAL/INSTALLATION PROCESS. PERSONNEL ARE

REQUIRED TO WEAR A FACE SHIELD, APRON, AND GLOVES.

0037 00-30