Figure 11. Roof components to be removed.

II113300-1-103

Rev. A

s) Remove the Light Bracket located on top of the Cab (see Figure 11). The Light Bracket

is attached to the back side of the cab with four bolts. Open the access door to reach

their location (see Figure 11). Remove the bolts, and then re-install them once the

bracket has been removed to fill the holes.

Remove the Roof Panel shown in Figure 11. This is done by unscrewing all of the bolts

located around the perimeter of the Panel. The Panel may have some sealant between

its bottom surface and the top of the cab; if so, it may be necessary to pry around the

edge of the Panel to remove it.

Remove bolts all

Roof Panel

around the perimeter

of the Roof Panel

Light Bracket

Remove Bolts

(Open Door to

Access Bolts)

Figure 11. Roof components to be removed.

u) Remove the Electrical Connector and Glad Hands located under the front of the vehicle,

as shown in Figure 12. This is done by removing the bolts and screws that attach these

items to the adjacent vertical plate. Disconnect the airline hoses from the Glad hands.

v) Disconnect the Steering Link form the Power Steering Arm. This is done by removing

the bolt shown in Figure 12 and then pushing the connecting pin out of the hole in the

Arm.

w) Remove the Torque Rod (see Figure 13) by disconnecting two bolts located at both ends

of the Rod.

CAUTION

Do not move the vehicle after the Torque Rod has been removed. Doing

this may make the Torque Rod difficult to re-install.

0037 00-36