Install Armor Kit, Windshield, PLS, P/N 113380-1-103

II113300-1-103

Rev. A

Page 41

Locate the Strap Assembly attachment point on the top of the door frame as shown in

m) Mark the location of the Strap Assembly attachment point using a center punch and

hammer.

n) Using a drill and a 3/16-in. drill bit, drill a pilot hole though one side of the door pillar

tubing in the marked position.

o) Drill through the pilot hole with a series of drill bits until a final hole size of 17/32-in

diameter is in the door pillar.

p) Install the Strap Assembly to the door pillar using one bolt (3/8 16 x 3.000 LG), two

washers (3/8 ID), and two flange bushings (P/N 1114111-1), one on each side of the

tube, and one locknut (3/8 16) torqued to 10 ft-lb (see Figure 29).

q) Install the Door Striker Base and Striker Pin, as shown in Figure 26.

r) Locate and mark the holes for the Door Striker Support using a center punch and a

hammer, as shown in Figure 27. The Door Striker Support should butt up against the

bottom edge of the Door Striker Base, adjust as required.

s) Using a drill and a 3/16-in. drill bit, drill a pilot hole though one side of the door pillar in

the positions that were marked.

Using a drill and a 17/32-in drill bit, drill through the pilot holes in the door pillar.

u) Install two Rivnuts (0.312-18 X 0.027-0.150 Grip) using the Rivnut Installation Tool (see

v) Attach the Door Striker Support (P/N 113327-1), as shown in Figure 26, using two

0.312-18 x 1.00 Long Cap Head Bolts.

0037 00-53