Figure 48. Upper Brush Guard Armor Panels.

II113300-1-103

Rev. A

g) Install the Upper Brush Guard Assembly using two 0.375-16 x 0.875-in. long Hex Head

Bolts in the locations shown in Figure 48.

Figure 48. Upper Brush Guard Armor Panels.

h) Using a lifting strap and material handling equipment (hoist, forklift, etc.), orient the

Lower Brush Guard as shown in Figure 49. A hand winch can be attached to the bottom

edge of the Brush Guard and frame of the vehicle to assist in positioning the Brush

Guard. Place the Brush Guard into position over the studs.

CAUTION

Do not allow the Lower Brush Guard to rotate once it is placed on the

studs. Doing this will cause the studs to bend and the threads will be

distorted. In addition, use caution when using a drift pin to line up any

threaded holes. Excessive force will damage the threads.

0037 00-77