DRAFT
TB 9-2320-364-13&P-1
AC HEATER/EVAPORATOR BLOWER OPERATES BUT NO COLD AIR FROM
DUCTS DURING AC OPERATIONS - Continued
WARNING
Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around
vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short
across electrical circuits or terminals and cause damage to equipment or severe burns or
electrical shock to personnel.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
VOLTAGE TEST
(1) If OFF, turn engine start switch ON
(TM 9-2320-364-10).
(2) Place positive (+) probe of multimeter on AC
condenser assembly harness black wire at AC
condenser motor solenoid terminal.
(3) Place negative (-) probe of multimeter on a known
good ground.
(a) If 22 to 28 vdc are not measured, turn engine
start switch OFF and repair AC condenser
assembly harness black wire (see Appendix A).
Verify repair, go to Step 29 of this fault.
(b) If 22 to 28 vdc are measured, go to Step 21 of
this fault.
PLSAC195
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -