DRAFT
TB 9-2320-364-13&P-1
AC HEATER CONTROL PANEL LIGHTS DO NOT OPERATE - Continued
WARNING
Remove rings, bracelets, wristwatches, neck chains, and any other jewelry before working around
vehicle. Jewelry can catch on equipment and cause serious injury. Jewelry or tools may short
across electrical circuits or terminals and cause damage to equipment or severe burns or
electrical shock to personnel.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
VERIFY REPAIR
(1) If ON, turn engine start switch OFF
(TM 9-2320-364-10).
(2) If removed, install optic ribbon light source lamp
(3) If removed, install optic ribbon light source lamp
socket in optic ribbon light source (WP 0043).
(4) If removed, install optic ribbon light source
(5) Install heater compartment access panel and eight
screws (TM 9-2320-364-20).
(6) Turn engine start switch ON (TM 9-2320-364-10).
(7) Inspect fan control switch, heater cable, defrost
cable, AC cable, and temperature control switch
labels for illumination.
(a) If all five labels do not illuminate, fault has not
been corrected. Turn engine switch OFF and
notify Supervisor.
(b) If all five labels illuminate, fault has been
corrected.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
PLSAC221
END OF WORK PACKAGE
0016-9/(0016-10 blank)