TB 9-2320-364-13&P-2
ROOF ARMOR REPLACEMENT - CONTINUED
0023 00
REMOVAL - CONTINUED
8
1
9,10,11,12
6,7
2,3,4,5
23,24,
25
13
14
22
20,21
15
19
(HIDDEN)
18 (HIDDEN)
17
417-055
16
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
1.
If removed, install stud plate (7) and two lifting eyes (6) on roof armor (19).
2.
Install two storage brackets (8), four washers (11), bolts (12), washers (10), and new locknuts (9) on roof armor (19).
3.
Install stud plate (25), four washers (24), and new locknuts (23) on roof armor (19).
4.
If removed, install new escape hatch seal (22) on roof armor (19).
5.
Install two stud plates (18) on front edge of roof armor (19). Hold stud plates to roof armor with two loosely installed
locknuts (17) on each stud plate.
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
N OT E
Roof armor weighs 219 lb (99.3 kg).
6.
Attach sling and lifting device to two lifting eyes (6).
0023 00-3
