II113301
Rev. -
Page 8
3. SIDE APPLIQUE ARMOR KIT INSTALLATION
3.1 REQUIRED TOOLS, EQUIPMENT, AND MATERIALS
The equipment and materials required to install the Side Applique Armor Kit onto the PLS are
provided in Table 4.
Table 4. Equipment and materials required to install the Side Applique Armor Kit
Description
Part Number
Automotive General Mechanics Tool Kit
SC5180-90-N26
Fork Lift / Overhead Hoist
Commercially Available
1/2-in. Drill
Commercially Available
1/4-in. Drill Bit
Commercially Available
Loctite 242 (Blue) or Loctite Quickstix 248
Commercially Available
Lift Straps
Commercially Available
1/2-in.-Drive 0-150 ft-lb Torque Wrench
Commercially Available
3/8-in.-Drive 0-960 in.-lb Torque Wrench
Commercially Available
3.2 GENERAL INSTALLATION INSTRUCTIONS
These Installation Instructions will provide the illustration directly after that installation callout,
and the text will be on either the same page or the facing page, where practical.
Before beginning the assembly of a part, remove all corrosion-preventative compound (if any)
and any accumulated foreign matter.
Screws and bolts are required to be installed with Loctite 242 or the Loctite Quickstix 248
supplied with the Kit.
Unless otherwise specified in the Installation Instructions, use the torque values provided in
Appendix A to torque all fasteners.
3.3 PERSONNEL SKILL LEVEL
The installation skill level required to complete the installation of the Kit shall be MOS 63S,
Heavy Wheeled Vehicle Mechanic.
0037 01-15