II113301
Rev. -
Page 15
q. Assemble the Door Handle Shaft (P/N 114607-1) to the existing shaft of the new
Door Handle (P/N 113335-3) using the Collar (P/N 114608-1) and two Spring Pins
(see Figure 4).
r.
Insert the Door Handle Assembly Shaft through the Door Armor Panel and secure it
with socket head screws / washers (D21).
s. Re-attach the Inside Door Handle (removed previously) by tightening the Handle set
screw.
t.
Mount the Side Mirror (removed previously) using mounting bolts / washers (D22).
u. Torque the bolts to the values in Appendix A.
3.4.1.4 Install Passenger-Side Door Applique Armor Panel (P/N 114601-1)
Repeat Steps a through u from Section 3.5.1.3, to install the Passenger-Side Door Armor Panel
(P/N 114601-1).
See Figures 2 and 4 for illustrations showing the location of hardware that is removed during the
Kit installation and the installation of the Passenger-Side Door Applique Armor Panel.
3.4.1.5 Install Driver's-Side Aft Applique Armor Panel (P/N 114603-1)
See Figures 2 and 5 for illustrations showing the location of hardware that is removed during the
Kit installation and the installation of the Driver's-Side Door Applique Armor Panel (P/N 114603-1).
a. Remove the aft Grab Handle, mounting hardware, and Plate (see Figure 2).
b. Remove and reverse (with the bolt heads to the nut side) three bolts / nuts / washers on
the Aft Angle Bracket (see Figure 2). Re-torque to the values listed in Appendix A.
c. Remove three bolts / nuts / washers from the Aft Angle Bracket (see Figure 2).
NOTE
All bolts threading into the Spacers (P/N 114606-3) or Mounts (114604-1) shall
be secured with the Threadlocker (Loctite) (P/N 37684) or its equivalent.
d. Attach three Mounts (P/N 114604-1) to the Aft Angle Bracket using locknuts / washers
(A1). Snug the locknuts tight.
e. Insert bolts / washers (A2) through the Aft Armor Panel Plates (A3) from inside of the
cab and attach threaded spacers (A4) (see Figure 5).
f.
Lift the Armor Panel Side, Aft (P/N 114603-1) and attach it to the Mounts (P/N 114604-1)
on the Aft Angle Bracket using mounting bolts / washers (A5). Snug the bolts tight.
g. Attach the Grab Handle (removed previously) using bolts / washers (A6). Snug the bolts
tight.
h. Align the gap between the Aft Armor Panel and the Door edge to a 1/8-in.-minimum gap.
0037 01-22
