|
| |
TM 9-2320-364-10
2-256
2-29. LOAD HANDLING SYSTEM (LHS) (CONT).
NOTE
If flatrack is being loaded in soft soil conditions, perform
Steps (14) a through c, then continue with Step (15).
(a)
Release joystick (1). Set hydraulic selector switch (2) to MAN H.A.
(b)
Move joystick (1) to LOAD until flatrack is approximately 2 ft.
(0.61 m) off the ground. Release joystick.
(c)
Set hydraulic selector switch (2) to AUTO. Resume normal AUTO
operations.
NOTE
Engine speed will require increasing and decreasing in the
following steps to facilitate performance.
(15)
After flatrack contacts rear rollers (12), increase engine speed to
approximately 1500 rpm until flatrack is nearly loaded. Reduce engine
speed to idle.
(16)
Continue loading until engage flatrack is fully loaded and LHS NO TRANS
lamp (3) extinguishes.
(17)
Release joystick (1).
(18)
Apply parking brake (13).
|
