|
| |
TM 9-2320-364-10
2-257
NOTE
If flatrack is not engaged in load locks, raise flatrack
slightly and lower again. Flatrack should set completely
and engage load locks.
(19)
Inspect that both load locks (14) have engaged and flatrack is completely
down on truck.
Engine speed must be at idle before using hydraulic selector
switch, or damage to equipment may result.
Hydraulic selector switch must be in OFF position before
driving or hydraulic system could overheat.
(20)
Turn hydraulic selector switch (2) to OFF.
c.
Off-Loading Flatrack in Auto Mode.
(1)
Check area for sufficient operating room at front and rear of truck. Check
overhead clearance and ground conditions.
(2)
Apply service brake pedal (9) and set transmission range selector (7) to
Neutral (N).
Ensure parking brake is not applied during unload sequence or
damage to equipment may result.
(3)
Set hydraulic selector switch (2) to AUTO.
|
