|
| |
TM 9-2320-364-20-2
2-1217
(1) Open top engine cover
(TM 9-2320-364-10).
(2) Disconnect wire 1029 from beacon
light.
(3) Set multimeter select switch to
volts dc.
(4) Connect positive (+) multimeter
lead to wire 1029.
(5) Connect negative (–) multimeter
lead to a known good ground.
(6) Turn ON ENGINE switch.
(7) Turn on beacon light switch.
(a) If 10 to 14 vdc are not present,
perform Steps (8) through (10)
below and go to Step 3 of this
Fault.
(b) If 10 to 14 vdc are present,
perform Steps (8) through (10)
below and go to Step 2 of this
Fault.
(8) Turn off beacon light switch.
(9) Turn OFF ENGINE switch.
(10) Connect wire 1029 to beacon light.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
