|
| |
TM 9-2320-364-20-3
2-2503
B
C
A
D
E
F
G
H
POWERBOX
TERMINAL C
(1) Disconnect connector MC135 from
powerbox.
(2) Set multimeter switch to OHMS.
(3) Is there continuity between wire 1435
connector MC135 terminal C and a
known good ground?
(a) If there is continuity, repair wire
1435 (see schematic Fig 2-56)
or notify DS Maintenance.
(b) If there is continuity, perform Step (4)
below and go to Step 16
of this Fault.
(4) Connect connector MC135 to powerbox.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
CONNECTOR
MC135
|
