|
| |
TM 9-2320-364-20-4
5-8
5-2. MUFFLER REPLACEMENT (CONT).
NOTE
If truck is not equipped with a
crane perform Steps (12) through
(14).
(12)
Install two angle brackets (30) on muffler
guard (24) with two screws (29) and
locknuts (28).
(13)
Install muffler guard (24) on muffler
guard (27) with two washers (26) and self-
locking screws (25). Tighten screws to 22
to 28 lb-ft (30 to 38 N.m).
(14)
Install two screws (23) and locknuts (22) on
muffler guard (27).
(15)
Position exhaust tube (20) on exhaust
tube (21).
(16)
Position exhaust tube (20) on muffler (8).
(17)
Install U-bolt clamp (19) and two
locknuts (18) on exhaust tube (20). Tighten
U-bolt clamp to 35 lb-ft (47 N.m).
NOTE
Partially tighten larger diameter
first (approximately half closed).
Partially tighten smaller
diameter second (approximately
half closed).
(18)
Position clamp (17) over exhaust tube (20)
and install two screws (16) and
locknuts (15). Tighten to 40 to 60 lb-ft
(54 to 81 N.m).
|
