|
| |
TM 9-2320-364-20-4
7-163
e.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
NOTE
Right side and left side are
installed the same way.
Right side is shown.
Refer to Table 7-4 for wire
numbers of right and left
lights.
(1)
Apply adhesive sealant on rear of composite
light (13).
(2)
With the aid of an assistant, install wire
483 (6), wire 491 (8) and wire 460 (10)
through composite light wiring harness
access hole (14).
(3)
Install two lockwashers (12) and screws (11)
in rear of composite light (13) through cab
wall (15).
(4)
Connect wire 1001 (9) to wire 460 (10).
(5)
Connect wire 1008 (7) to wire 491 (8).
(6)
Connect wire 1680 (5) to wire 483 (6).
Left Light Right Light
1002/460
1001/460
1008/491
1008/491
1680/483
1680/483
Table 7-4. Front Composite Light/Bracket
Wires.
|
