|
| |
TM 9-2320-364-20-4
7-169
e.
Installation.
(1)
Install two composite light mounting
brackets (15), two screws (20) and
locknuts (19) on frame (21).
(2)
Install cushion clip (18), screw (17) and
locknut (16) on composite light mounting
brackets (15).
(3)
Position ground wire (12), two washers (11),
lockwasher (10), screws (9) and
spacers (14) on composite light mounting
bracket (15).
(4)
Position composite light (13) in composite
light mounting bracket (15) and tighten two
screws (10).
NOTE
Refer to Table 7-5 for wire
numbers of right and left
lights.
Feed wires through rear of
bracket during installation.
(5)
Connect wire 1008 (7) to wire 21 (8).
(6)
Connect wire 1003 (5) to wire 22 (6).
(7)
Connect wire 1680 (3) to wire 24 (4).
(8)
Connect wire 1678 (1) to wire 23 (2).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and
are harmful to skin and clothing.
To avoid injury or death, keep
away from open fire and use
in well-ventilated area. If
adhesive, solvent, or sealing
compound gets on skin or
clothing,wash immediately with
soap and water.
(9)
Apply corrosion preventive compound to
ground wire (4).
Left Light Right Light
1678/23
1678/23
1680/22
1680/24
1003/22
1004/22
1008/21
1008/21
Table 7-5. Front Composite Light/Bracket
Wires.
|
