|
| |
TM 9-2320-364-20-4
7-191
d.
Assembly.
Keep all moisture and oils off
lamp. Do not touch lamp with
bare hands. Use a clean dry, oil
free cloth to hold lamp while
installing lamp in blackout light.
NOTE
There are two blackout
lights. Both blackout lights
are installed the same way.
Replace cable ties as
required.
(1)
Install gasket (10), blackout light
assembly (9), two self-tapping screws (7)
and nut (8) on rear light bar assembly (11).
Corrosion inhibitor contains
alkali. Do not get in eyes; wear
goggles/safety glasses when
using. Avoid contact with skin. In
case of contact, immediately
wash area with soap and water. If
eyes are contacted, flush eyes
with large amounts of water for
at least 15 minutes and get
immediate medical attention.
(2)
Apply anti-corrosion silicone compound to
inside of lamp socket (6).
(3)
Install blackout lamp (5) in blackout lamp
socket (6).
(4)
Install lens cover (4) with two screws (3) in
blackout light assembly (9).
(5)
Connect wire 1680 (1) to wire 490 (2).
|
