|
| |
TM 9-2320-364-20-4
7-199
b.
Disassembly.
(1)
Apply soap solution to edge of sealed
beam (1) and pry off from hand held work
lamp assembly (2).
(2)
Loosen two screws (3) and remove wire
1435 (4) and wire 1040B (5) from rear of
sealed beam (1).
(3)
Remove and discard end splice cap (6) from
switch wire (7).
(4)
Remove switch retainer nut (8) from front of
switch (9).
(5)
Remove switch (9) from hand held work
lamp assembly (2).
(6)
Remove nut (10) from hand held work lamp
assembly handle (11).
(7)
Remove hand held work lamp assembly
handle (11) from hand held work lamp
assembly housing (2).
(8)
Remove connector (12) and wire
harness (13) from hand held work lamp
assembly handle (11).
NOTE
Note position of wire pins before
disassembly of connector.
(9)
Remove connector adapter (14) from
connector housing (15).
Use care when removing
retaining rings. Retaining rings
are under spring tension and can
act as projectiles when released
and could cause severe eye
injury.
(10)
Remove retaining ring (16) from electrical
connector housing (15).
(11)
Remove two wire pins (17) and wire pin
guide (18) from connector housing (15).
(12)
Remove connector adapter (14) from wire
harness (13).
|
