|
| |
TM 9-2320-364-20-4
7-209
NOTE
Perform Steps (13) through (16)
if cold plate was removed.
(13)
Install shield (11) and two screws (9) on
engine cold plate (12). Tighten screws
156 to 204 lb-in (17-23 N.m).
(14)
Install two fuel lines (7) on plastic fitting
block (8).
(15)
Position engine lifting bracket (3) on
balance cover (6) with lockwasher (5)
(2) and screws (4) and (1).
(16)
Tighten screw (1) on engine lifting
(3) to 71 to 75 lb-ft (96-102 N.m).
(17)
Tighten screw (4) on engine lifting
(3) to 53 to 56 lb-ft (72-76 N.m).
(18)
Tighten screw (1) on engine lifting
(3) to 103 to 110 lb-ft (140-149 N.m).
(19)
Tighten screw (4) on engine lifting bracket
(3) to 71 to 75 lb-ft (96-102 N.m).
c.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Start engine, (TM 9-2320-364-10).
Check for leaks, (TM 9-2320-364-10).
Shut OFF engine, (TM 9-2320-364-10).
Install cab engine access panel, (Para 17-24).
Close engine cover, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
