|
| |
TM 9-2320-364-20-4
7-219
b.
Installation.
(1)
Install potentiometer (16) on throttle
sensor (2) with two washers (15) and
screws (14).
(2)
Install throttle sensor (2) on throttle sensor
mounting bracket (13) with two screws (12)
and locknuts (11).
(3)
Position bracket (8) on cab (10) with two
screws (9).
Throttle position switch must be
installed so it is activated 0.12 in.
to 0.19 in. (3 mm to 5 mm)
before full throttle position.
Failure to comply may result in
engine overheating.
(4)
Install throttle position switch (7) on bracket
(8) with screws (6), two washers (5) and
locknuts (4).
(5)
Tighten two screws (9) on bracket (8).
(6)
Connect MC127 connector (3).
(7)
Connect MC6 connector (1) to throttle
sensor (2).
c.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Start engine, (TM 9-2320-364-10).
Check operation of throttle sensor, (TM 9-2320-364-10).
Shut OFF engine, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
