|
| |
TM 9-2320-364-20-4
7-350
7-101. GENERAL WIRE HARNESS REPAIR (CONT).
b.
Type 2 Connector Repair.
Terminals come in different
styles and sizes. To prevent
damage, be sure to use only the
exact replacements. Do not
attempt to modify terminal to fit.
NOTE
Repeat procedure as necessary.
(1)
Disassembly.
(a)
Remove two screws (1) and cable
clamp (2) from connector (3).
(b)
Remove heat shrink (4).
(c)
Remove wire (5) and terminal (6)
from connector (3).
NOTE
Cut as close to damaged terminal
as possible.
(d)
Cut off terminal (6) at end of wire (5).
Remove insulation (7) 1/4 inch (.635 cm)
from end of wire (3). Discard terminal.
(2)
Assembly.
(a)
Install terminal (6) on connector (3).
(b)
Install cable clamp (2) on connector (3)
with two screws (1).
(c)
Install heat shrink (4) around wires (5).
|
