|
| |
TM 9-2320-364-20-4
7-351
c.
Type 3 Connector Repair.
(1)
Disassembly.
(a)
Slide outer shell (1) back on wire (2).
(b)
Remove C-washer (3) from wire (2).
(c)
Cut terminal (4) from wire (2).
(d)
Trim end of wire (2) as needed to make
an undamaged end.
NOTE
If trimming causes wire to
become too short, refer to
TM 43-0158.
(e)
Remove 0.375 in. (1.0 cm) of
insulation (5) from end of wire (2).
(2)
Assembly.
(a)
Install terminal (4) on wire (2).
(b)
Install C-washer (3) on wire (2) just
below terminal (4).
(c)
Slide outer shell (1) over C-washer (3)
and terminal (4).
(d)
Be sure no bare wire (2) is visible
outside of outer shell (1).
|
