|
| |
TM 9-2320-364-20-4
7-352
7-101. GENERAL WIRE HARNESS REPAIR (CONT).
d.
Type 4 Connector Repair.
(1)
Disassembly.
(a)
Slide outer shell (1) and sleeve (2)
back on wire (3).
(b)
Remove contact (4) from wire (3).
(c)
Trim end of wire (3) as needed to
make an undamaged end.
NOTE
If trimming causes wire to
become too short refer to
TM 43-0158.
(d)
Remove 0.25 in. (.6 cm) of
insulation (5) from end of wire (3).
(2)
Assembly.
(a)
Install sleeve (2) over end of wire (3).
(b)
Install contact (4) over end of wire (3).
(c)
Crimp contact (4) securely in place.
(d)
Slide outer shell (1) over sleeve (2) and
contact (4).
(e)
Be sure no bare wire (3) shows outside
of outer shell (1).
|
