|
| |
TM 9-2320-364-20-4
7-353
e.
Group I Terminal Repair.
(1)
Disassembly.
Tip of removal tool is very sharp.
Use caution when using tool.
Failure to comply may result in
injury to personnel.
NOTE
Locking tab on the terminal
mates with molded tab in
plastic connector to retain
cable assembly.
All Group I connectors are
repaired the same way.
Number of wires in
connection may vary.
(a)
Insert tip of removal tool between
locking tab (1) of terminal (2) and wall
of connector (3).
(b)
Release locking tab (1) from
connector (3).
(c)
Push terminal (2) through front of
connector (3).
NOTE
Perform Step (d) only if old
terminal is still attached to
wire.
Make cut directly behind
damaged terminal.
(d)
Cut and remove terminal (2) from
wire (4). Discard terminal.
(e)
Remove wire (4) and seal (5) from
connector (3).
|
