|
| |
TM 9-2320-364-20-4
7-354
7-101. GENERAL WIRE HARNESS REPAIR (CONT).
(2)
Assembly.
(a)
Push wire (4) through seal (5) and
connector (3) cavity.
Strip wire after placing it through
seal and connector body to
prevent damage to individual
strands.
(b)
Strip end of wire (4) using crimp tool
leaving 1/4 in. (0.64 cm) of bare wire.
NOTE
When installing terminal be sure
terminal wings point to the upper
jaw of crimping tool.
(c)
Push terminal holder open and insert
terminal (2) until attaching portion of
terminal rests on anvil.
|
