|
| |
TM 9-2320-364-20-4
7-355
NOTE
Wire should be positioned so
larger wings of terminal will
crimp around insulation and
smaller wings will crimp
around exposed bare wire.
(d)
Position wire (4) on terminal (2).
(e)
Press handle(s) of crimp tool together
until ratchet releases and crimp is
complete.
NOTE
Locking tab should be positioned
toward notch in connector cavity
when properly installed.
(f)
Pull wire (4) and terminal (2) back
through connector (3) until seated.
(g)
Seat seal (5) into connector (3).
f.
Group II Terminal Repair.
(1)
Disassembly.
NOTE
Connector is removed by
gently prying up on clip and
pulling on connector.
All Group II connectors are
repaired the same way.
Number of wires in
connector may vary.
Both halves of connector are
repaired the same way.
(a)
Disconnect connector (1).
(b)
Unlatch and open two secondary
locks (2) on connector (1).
|
