|
| |
TM 9-2320-364-20-4
7-356
7-101. GENERAL WIRE HARNESS REPAIR (CONT).
Tip of removal tool is very sharp.
Use caution when using tool.
Failure to comply may result in
injury to personnel.
(c)
Insert removal tool into cavity (3) on
connector (1) until seated.
(d)
Pull wire (4) back through
connector (1) and remove tool.
NOTE
Perform Step (e) only if old
terminal is still attached to
wire.
Make cut directly behind
damaged terminal.
(e)
Cut terminal (5) and wire seal (6) from
wire (4). Discard terminal and seal.
(2)
Assembly.
(a)
Insert 1 in. (2.5 cm) of wire (4) through
new wire seal (6).
Strip wire after placing it through
seal to prevent damage to
individual wire strands.
(b)
Strip end of wire (4) leaving 1/4 in.
(0.64 cm) of bare wire.
|
