|
| |
TM 9-2320-364-20-4
7-357
(c)
Insert new terminal (5) in locating hole
of crimp tool using proper hole according
to the gage of wire (4).
(d)
Slide seal (6) down to end of
insulation (7) on wire (4).
NOTE
Wire and seal should be
positioned so larger wings of
terminal will crimp around seal
and smaller wings will crimp
around exposed bare wire.
(e)
Position wire (4) on terminal (5).
(f)
Press handles of crimp tool together
until ratchet releases and crimp is
complete.
(g)
Push new terminal (5) and wire (4)
through connector (1) until seated.
(h)
Close two secondary locks (2) on
connector (1).
(i)
Connect connector (1).
|
