|
| |
TM 9-2320-364-20-4
7-358
7-101. GENERAL WIRE HARNESS REPAIR (CONT).
g.
Group III Terminal Repair.
(1)
Disassembly.
NOTE
Connector is removed by
gently prying up on clip and
pulling on connector.
All Group III connectors are
repaired the same way.
Number of wires in
connector may vary.
Both halves of connector are
repaired the same way.
(a)
Disconnect connector (1).
(b)
Unlatch and remove two secondary
locks (2) on connector (1).
Tip of removal tool is very sharp.
Use caution when using tool.
Failure to comply may result in
injury to personnel.
(c)
Insert removal tool into terminal
connector cavity (3) until seated.
(d)
Pull wire (4) back through
connector (1) and removal tool.
|
