|
| |
TM 9-2320-364-20-4
7-359
NOTE
Perform Step (e) only if old
terminal is still attached to
wire.
Make cut directly behind
damaged terminal.
(e)
Cut off terminal (5) and wire seal (6).
Discard terminal and seal.
(2)
Assembly.
(a)
Insert 1 in. (2.5 cm) of wire (4) through
new wire seal (6).
Strip wire after placing it through
seal to prevent damage to
individual wire strands.
(b)
Strip end of wire (4) leaving 0.25 in.
(0.64 cm) of bare wire.
(c)
Insert new terminal (5) in locating hole
of crimp tool using the proper hole
according to gage of wire (4).
(d)
Slide wire seal (6) down to end of
insulation (7) on wire (4).
|
