|
| |
TM 9-2320-364-20-4
7-362
7-101. GENERAL WIRE HARNESS REPAIR (CONT).
(2)
Assembly.
(a)
Strip approximately 5/16 in (7.87
mm) of insulation (11) from end of
wire (8).
(b)
Install new cable seal (9) on wire (8).
(c)
Crimp new electrical contact (10) on
wire (8).
(d)
Install wire (8) in connector (3) until it
locks.
(e)
Install secondary lock(s) (7) in
connector (3).
NOTE
Perform Step (f) only if cab
connector was removed.
(f)
Install cab connector (3) on cab (6)
with two screws (5) and new
locknuts (4).
(g)
Install harness connector (2) on cab
connector (3) with screw (1).
i.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
