|
| |
TM 9-2320-364-20-4
7-364
7-102. ENGINE BRAKE WIRE HARNESS REPLACEMENT (CONT).
(2)
Remove rubber harness support (4) from
injector lines (5).
(3)
Disconnect spade connector (6) from
terminal assembly (7).
(4)
Disconnect spade connector (8) from
terminal assembly (7).
(5)
Remove terminal assembly (7) from
cylinder head (9).
(6)
Remove engine brake harness (1) from
cylinder head (9).
b.
Installation.
NOTE
There is one brake wiring
harness in each cylinder
head. Both brake wiring
harnesses are installed the
same way. Right side shown.
Install cable ties as noted
during removal.
(1)
Position engine brake harness (1) in cylinder
head (9).
(2)
Install terminal assembly (7) in cylinder
head (9).
(3)
Connect spade connector (8) on terminal assembly (7).
(4)
Connect spade connector (6) on terminal assembly (7).
(5)
Install rubber harness support (4) on injector lines (5).
(6)
Connect positive lock connectors (2) on engine brake solenoids (3).
c.
Follow-On Maintenance:
Install left or right rocker cover, (Para 3-4 or Para 3-5).
Connect batteries, (Para 7-87).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
