|
| |
TM 9-2320-364-20-4
8-3
b.
Disassembly.
(1)
Remove four screws (5) and locknuts (6)
from shift selector cover assembly (7).
Discard locknuts.
(2)
Remove mounting bracket (8) from shift
selector housing (9).
NOTE
Perform Step (3) if foam tape is
damaged.
(3)
Remove foam tape (10) from bottom of
mounting bracket (8).
(4)
Remove four screws (11) and
lockwashers (12) from rear of shift selector
housing (9). Discard lockwashers.
Use caution when removing shift
selector cover assembly. Cover
assembly is plugged into circuit
board assembly. Failure to use
caution may cause damage to
cover assembly or circuit board
assembly.
(5)
Remove shift selector cover assembly (7)
and gasket (13) from shift selector
housing (9). Discard gasket.
(6)
Disconnect and remove circuit board
assembly (14) from shift selector
housing (9).
(7)
Remove three lamps (15) from circuit board
assembly (14).
c.
Assembly.
(1)
Install three lamps (15) in shift selector
circuit board assembly (14).
(2)
Connect circuit board assembly (14) in shift
selector housing (9).
|
