|
| |
TM 9-2320-364-20-4
8-4
8-2. TRANSMISSION SHIFT SELECTOR REPAIR (CONT).
Use caution when installing shift
selector cover assembly. Cover
assembly has to be plugged into
circuit board assembly. Failure
to use caution may cause damage
to cover assembly or circuit
board assembly.
(3)
Position shift selector cover assembly (7)
and gasket (13) on shift selector housing (9).
(4)
Install four lockwashers (12) and screws (11)
in rear of shift selector housing (9).
NOTE
Perform Step (5) if foam tape
was removed.
(5)
Install foam tape (10) on mounting
bracket (8).
(6)
Install mounting bracket (8) on shift selector
housing (9).
(7)
Install four screws (5) and locknuts (6) in
shift selector cover assembly (7).
d.
Installation.
(1)
Connect MC12 connector (4) on rear of shift
selector assembly (3).
(2)
Install four screws (1) in shift selector
assembly (3) and install shift selector
assembly (3) onto shift selector mounting
bracket (2).
e.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
