|
| |
TM 9-2320-364-20-4
9-6
9-3. TRANSFER CASE DIFFERENTIAL AIR CHAMBER REPLACEMENT (CONT).
(3)
Remove locknut (8) and copper washer (9)
from inside top of air chamber (7). Discard
locknut and copper washer.
(4)
Remove two screws (10) and
lockwashers (11) from base of air
chamber (7). Discard lockwashers.
(5)
Remove air chamber (7) from rear
housing (12).
(6)
Remove copper washer (13) from end of
shift rod (14). Discard copper washer.
NOTE
Tag and mark position of elbows
and reducers prior to removal.
(7)
Remove elbow (3), reducer (15) and
elbow (4) from air chamber (7).
b.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and
are harmful to skin and clothing. To avoid injury or death, keep away from open fire and use
in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing,
wash immediately with soap and water.
(1)
Coat threads of elbow (3), reducer (15) and elbow (4) with adhesive sealant.
NOTE
Install elbows and reducer in position noted prior to removal.
(2)
Install elbow (3), reducer (15) and elbow (4) in air chamber (7).
(3)
Install copper washer (13) on shift rod (14).
(4)
Coat threads of two screws (10) and bottom lip of air chamber (7) with adhesive.
NOTE
If shift rod is not fully extended, locknut cannot be installed.
(5)
Pull shift rod (14) out of rear housing (12) as far as possible.
(6)
Install air chamber (7) on rear housing (12) with two screws (10) and lockwashers (11). Tighten screws
to 25 lb-ft (34 N.m).
|
