|
| |
TM 9-2320-364-20-4
9-17
(4)
Install transfer case shift cable (3) on
bracket (11) with jam nuts (10).
(5)
Adjust transfer case shift cable (3) until
cable and adjusting clevis (9) are aligned
and tighten jam nuts (10).
(6)
Install yoke pin (8) and cotter pin (7) in
adjusting clevis (9) and transfer case shift
cable (3).
NOTE
Measurement in Step (7) should be 2-11/16 in. (68 mm) when transfer case is in neutral.
(7)
Measure shift rod (19) extension from transfer case housing (20) to rear of shift rod jam nut (21).
2–11/16 IN.
(68 MM)
|
