|
| |
TM 9-2320-364-20-4
10-4
10-2. DRIVESHAFT AND UNIVERSAL JOINT REPAIR (CONT).
b.
Disassembly.
(1)
Position driveshaft (1) on clean work surface.
NOTE
There are two types of
bearing assembly fasteners.
Type B replaced Type A.
Type A uses lock straps with
hex head screws.
Type B uses serrated hex
head screws with lock
patches.
Perform Steps (2) and (3) for
Type A.
(2)
Bend four locking tabs (2) on two lock
straps (3) away from screws (4).
(3)
Remove and discard four screws (4) and
two lock straps (3) from slip yoke (5).
NOTE
Perform Step (4) for Type B.
(4)
Remove four screws (6) from slip yoke (5)
Discard screws.
Use caution when removing
bearing assemblies from yoke.
Needles in bearing assemblies
may be lost or damaged.
(5)
Remove two bearing assemblies (7) from
slip yoke (5).
(6)
Remove universal joint (8) from slip
yoke (5).
|
