|
| |
TM 9-2320-364-20-4
10-7
d.
Assembly.
(1)
Install grease fitting (15) in slip yoke (5).
(2)
Coat spline shaft (13) with grease.
(3)
Position dust cap (14) on spline shaft (13).
Matchmarks must be aligned as
marked during removal. Failure
to comply may result in damage.
(4)
Align matchmarks and install slip yoke (5)
on spline shaft (13).
(5)
Install dust cap (14) on slip yoke (5).
Tighten hand tight.
(6)
Install two grease fittings (12) in universal
joint (8).
Check valves must be installed
correctly or lubricant will not
flow correctly and cause damage
to equipment.
(7)
If removed, install four check valves (11) in
universal joint (8).
(8)
Coat inside of two bearing caps (10) with
grease.
(9)
Install two bearing caps (10) and retaining
wire (8) on universal joint (8).
|
