|
| |
TM 9-2320-364-20-4
10-8
10-2. DRIVESHAFT AND UNIVERSAL JOINT REPAIR (CONT).
(10)
Position universal joint (8) in slip yoke (5).
(11)
Coat inside of two bearing caps (7) with
grease.
(12)
Install two bearing assemblies (7) on slip
yoke (5) and universal joint (8).
NOTE
There are two types of
bearing assembly fasteners.
Type B replaced Type A.
Type A uses lock straps with
hex head screws.
Type B uses serrated hex
head screws with lock
patches.
Perform Steps (13) and (14)
for Type A.
(13)
Install two lock straps (3) and four
screws (4) on two bearing caps (10) and
slip yoke (5). Refer to Table 10-1 for
proper torque value and tighten screws.
(14)
Bend four locking tabs (2) on two lock
straps (3) against screws (4).
NOTE
Perform Step (15) for Type B.
(15)
Install four screws (6) on two bearing
assemblies (7) and slip yoke (5). Refer to
Table 10-2 for proper torque value and
tighten screws.
(16)
Repeat Steps (1) through (15) for
remaining universal joint (8).
|
