|
| |
TM 9-2320-364-20-4
11-23
This task covers:
a. Removal
c. Adjustment
b. Installation
d. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanic’s: Automotive
(Item 74, Appendix G)
Socket Set, Deep Well (Item 60, Appendix G)
Tape, Measurer (Item 66, Appendix G)
Wrench, Torque (0 to 175 lb-ft [0 to 237 N.m])
(Item 95, Appendix G)
Plate, Steel 1/8 in. by 1 in. by 8 in
(Appendix D)
11-10. STEERING STOP BOLT REPLACEMENT/ADJUSTMENT.
NOTE
All six steering stop bolts are removed and installed the same way. Axle No. 5 is shown.
a.
Removal.
(1)
Loosen jamnut (1) on steering stop bolt (2).
(2)
Remove steering stop bolt (2) from axle (3).
b.
Installation.
(1)
Position steering stop bolt (2) and jamnut (1) on axle (3).
(2)
Hold jamnut (1) while tightening steering stop bolt (2) until steering stop bolt (2) is fully seated against
axle (3).
|
