|
| |
TM 9-2320-364-20-4
12-22
12-5. BRAKE PRESSURE SWITCH REPLACEMENT (CONT).
NOTE
If only removing lower brake
switch, proceed to Step (4) of b.
Installation.
(4)
Remove nut (11), wire 1005 (12), wire
1005 (13) and washer (14) from terminal of
upper brake switch (15).
(5)
Remove nut (16), wire 1009 (17), wire
1009 (18) and washer (19) from terminal of
upper brake switch (15).
(6)
Remove upper brake switch (15) from pedal
valve (10).
b.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in a well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(1)
Coat threads of upper brake switch (15) with
sealing compound.
NOTE
Switch terminals should line up
vertically (one above the other)
when switch is installed.
(2)
Install switch (15) on brake valve (10).
|
