|
| |
TM 9-2320-364-20-4
12-41
b.
Installation.
(1)
Coat wedge assembly (15) with grease.
(2)
Install wedge assembly (15) in brake
assembly (16).
NOTE
Perform Step (3) if collet nut
was removed.
Install collet nut flat end
first on air chamber.
(3)
Install collet nut (14) completely on air
chamber (4).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
(4)
Apply sealing compound to first four threads
on air chamber (4).
(5)
Install air chamber (4) into brake
assembly (16) until air chamber bottoms out
in brake assembly.
Air chamber can only be turned
out a maximum of one turn.
Failure to comply may result in
damage to equipment.
(6)
Rotate air chamber (4) to align ports.
(7)
Position collet nut (14) on air chamber (4)
against brake assembly (16).
|
