|
| |
TM 9-2320-364-20-5
15-57
d.
Assembly.
(1)
Install two lube fittings (29) on coupler (2).
Use extreme care when compressing, releasing, removing or installing springs. Springs are
under tension and can act as projectiles when released. Ensure proper eye protection is worn
to prevent injury to personnel.
(2)
Position spring (28) and pin (27) on coupler (2).
(3)
Install roll pin (26) in pin (27).
(4)
Position spring (25) and pivot pin (24) on coupler (2).
(5)
Position locking lever (3) on pivot pin (24) and install roll pin (23)
(6)
Install roll pin (21) and key (22) on latch (19).
(7)
Position spring (20) latch (19) and latch pin (18) on coupler (2).
(8)
Position pull lever (4) on latch pin (18) and install nut (16).
(9)
Install roll pin (17) on latch pin (18).
(10)
Position locking gate (1) on coupler (2) and
install roll pin (15).
(11)
Position shank (14), on coupler (2) and
install four screws (12), screw (13) and five
locknuts (11). Tighten locknuts (11) to 210
lb-ft (285 N.m).
|
